Patent Pending

DANDY 2-SPEED ELECTRIC POWDER TRICKLER
                                       (Made in the USA)                                     
                                                                       

Your Subtitle text
 


The Dandy Auto Trickler


-------------------------------------------------------------------------
The Dandy 2-Speed Electric Powder Trickler
        
                                                                     

                                       



Handy View


                 
 HOW THE DANDY 2-SPEED ELECTRIC
POWDER TRICKLER OPERATES

Assembly of the Powder Trickler
On receipt of the new Dandy 2-Speed Electric Powder Trickler:
1.  Slide the hopper assembly onto the tower rod end.
2.  Install two (2) AA batteries into the hand-held control pad. 
3.  Depress the "yellow" and "red" buttons to check function.

**Note1:  If the powder trickler fails to operate, check the
battery installation.  If it still does not operate, hold the "red" button down and tap the hopper with a pencil or similar object. If it operates, let it run for approximately 30 seconds.**


The Dandy 2-Speed Powder Trickler is now ready for use, and
you can begin to load your powder and proceed with the ammunition 
reloading process.

**Note2:  Make sure you thoroughly clean the hopper, when
changing powders, so that you do not contaminate the next
reload.**


Flexibility
Once assembled, the flexibility of the Omega 2-Speed Electric Powder Trickler allows for placement of your ammunition reloading equipment on the bench in a number of ways, allowing for a more comfortable and efficient ammunition reloading experience.

The powder trickler's Hopper can be positioned at any angle (360 degree rotation) in relation to the base.
        
The height of the hopper can be adjusted from 1" to 5-1/2".     

The Discharge Tube on our powder trickler is angle cut for a view of the powder about to be dropped during the ammunition reloading process.

    

The Sliding Adjustable Weight gives the reloader the flexibilty of increasing or decreasing the speed of the powder flow.  By moving the weight towards the hopper, you can speed up the powder flow and moving back towards the end of the discharge tube, you can slow down the powder flow to one (1) kernel at a time, if so desired, no longer requiring tweezers to move that one kernel.


The Control Pad on our powder trickler has a "slow" (yellow) button and a "fast" (red) button to allow you to move the powder grains through the discharge tube as you require.  You can use the fast button to load the bulk of reloading powder and then use the slow button to maximize the accuracy of your load.



                          WARNING!!
DO NOT USE BLACK POWDER OR BLACK POWDER SUBSTITUTES IN THE DANDY 2-SPEED ELECTRIC POWDER TRICKLER.  BLACK POWDER CAN BE IGNITED BY STATIC DISCHARGE! 
 
---------------------------------------------------------------------------------------

 Operation of the Handy View

The prism slides up and down, within the stand, and swivels (around horizontal axis) to allow adjustment of the viewing angle.  The red dot on the prism should be facing the beam scale.  Adjust the prism until you see the alignment marks you are wanting to view.  **DISCONTINUED**



Phone:  1-602-826-7656  *  Email:  info@omegapowdertrickler.com
1041 N. 95th Place * Mesa, AZ  85207 

Website Builder